1. Hi,
    I am currently working on a system with vellum that transforms a line or any wire into a helix or any other polyline based on target angles. Any sugggestions on how to do this?

  2. Hi Mo
    I’m using Houdini 19. During the “stitch points” section at 18:00 in the video I have everything set up as you do. But no matter high I dial the braking threshold, the vellum geometry still brakes at the same stress level (which is the initial collision). Do you have any suggestions for how I can get the geometry to bend a bit before braking?

Leave a Reply to Charles Cancel reply